GENERAL
B1220, B1620, B1820, WSM
G-36
(EU)
[12] OTHERS
Bleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When the tank is completely empty.
3. After the tractor has not been used for a long period of time.
Bleeding procedure is as follows:
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and then stop
the engine.
9Y1210272GEG0038US0
Draining Clutch Housing Water
• The tractor is equipped with a water drain plug (1) under the
clutch housing.
• After operating in rain, snow or tractor has been washed,
water may get into the clutch housing.
1. Remove the drain plug and drain the water, then install the plug
again.
9Y1210272GEG0039US0
Replacing Fuse [B1220]
1. The tractor electrical system is protected from potential damage
by fuses.
A blown fuse indicates that there is an overload or short
somewhere in the electrical system.
2. If any of the fuses should blow, replace with a new one of the
same capacity.
• Before replacing a blown fuse, determine why the fuse blew
and make any necessary repairs. Failure to follow this
procedure may result in serious damage to the tractor
electrical system. Refer to the "TROUBLESHOOTING"
section of this manual.
Q Protected Circuit
9Y1210272GEG0040US0
(1) Drain Plug
Fuse No. Capacity (A) Protected Circuit
(1) Slow blow fuse
Check circuit against wrong battery
connection
(2) 15 A Key stop
(3) 10 A Auxiliary (Reserve)
(4) 20 A Head light, Key stop
(5) 15 A Auxiliary (Reserve)
(6) Reserve
(7) Reserve
To Next Page
Loading...
Need help?
General
