GENERAL
B1220, B1620, B1820, WSM
G-49
(EU)
9. TIRES
[1] TIRE PRESSURE
• Do not attempt mount a tire. This should be done by a qualified person with the proper equipment.
• Do not use tires larger than specified.
• When you intend to mount different size of tires from equipped ones, consult your distributor about front
drive gear ratio for detail.
• Excessive wear of tires may occur due to improper gear ratio.
Through the tire pressure is factory-set to the prescribed level,
it naturally drops slowly in the course of time. Thus, check it every
day and inflate as necessary.
To inflate the wheel tires, use an air compressor or hand pump.
Q Recommended inflation pressure
• Maintain the pressure shown below for normal use.
• Maintain the maximum pressure in front tires, if using a
front loader of when equipped with a full load of front
weights.
Q Dual Tires
• Dual tires are not approved.
9Y1210272GEG0045US0
Tire Sizes Inflation Pressure
Rear
7 - 16, 4PR 180 kPa (1.8 kgf/cm
2
, 26 psi)
8 - 16, 4PR 160 kPa (1.6 kgf/cm
2
, 23 psi)
9.5 - 16, 4PR 140 kPa (1.4 kgf/cm
2
, 20 psi)
212/80D - 15, 4PR 160 kPa (1.6 kgf/cm
2
, 23 psi)
29 × 12.00 - 15, 4PR 140 kPa (1.4 kgf/cm
2
, 20 psi)
Front
4.50 - 10, 4PR 220 kPa (2.2 kgf/cm
2
, 31 psi)
5 - 12, 4PR 240 kPa (2.2 kgf/cm
2
, 34 psi)
6 - 12B, 4PR 200 kPa (2.0 kgf/cm
2
, 29 psi)
20 × 8.00 - 10, 4PR 160 kPa (1.6 kgf/cm
2
, 23 psi)
20.5 × 8.00 - 10, 4PR 160 kPa (1.6 kgf/cm
2
, 23 psi)
(A) Insufficient
(B) Standard
(C) Excessive
(D) Ground
To Next Page
Loading...
Need help?
General
