KYMCO PEOPLE 250 Service Manual

13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
13-17
PEOPL E 25 0
Check the heater with battery.
If the heater is getting hot, means the heater
without problem, otherwise the heater has to
be changed.
CARBURETOR INSTALLATION
Tighten the drain screw.
Install the carburetor onto the intake manifold
and tighten the band.
Install the air cleaner connecting tube and
tighten the band.
Connect the throttle cable to the carburetor.
Connect the heater carburetion wire coupler.
Connect the auto bystarter wire.
Connect the fuel tube and vacuum tube to the
carburetor.
Connect the throttle position sensor wire.
Perform the following inspections and
adjustments:
•Throttle grip free play (
!
3-3)
•Idle speed (
!
3-6)
Install the seat, met-in box and frame body
cover.
Heater
Auto Bystarter Wire
Auto Bystarter
Fuel Tube
Intake Manifold Band
Air Cleaner Connecting
Tube Band
Throttle Cable
T.P.S
T.P.S Wire
Heater Carburetion
Wire Coupler
After connecting the throttle cable, adjust
the throttle grip free play to 2_ 6mm.
＊

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm