SERVICE INFORMATION
GENERAL INSTRUCTIONS
• A floor jack or other adjustable support is required to support and maneuver the engine. Be
careful not to damage the motorcycle body, cables and wires during engine removal.
• Use shop towels to protect the motorcycle body during engine removal.
• Drain the coolant before removing the engine.
• After the engine is installed, fill the cooling system with coolant and be sure to bleed air from the
water jacket. Start the engine to check for coolant leaks.
• Before removing the engine, the rear brake caliper must be removed first. Be careful not to bend
or twist the brake fluid tube.
SPECIFICATIONS
Engine oil capacity: at disassembly: 1.1 liter
TORQUE VALUES
Rear shock absorber upper mount bolt 35_ 45N-m
Rear shock absorber lower mount bolt 35_ 45N-m
Rear axle nut 110_ 130N-m
Engine hanger bolt (frame side) 45_ 55N-m
Engine hanger bolt (ENG. side) 45_ 55N-m
Rear caliper holder bolt 29_ 35N-m
Exhaust muffler pipe nut 18_ 22N-m
Exhaust muffler bolt 32_ 38N-m
Rear fork bolt 29_ 35N-m
To Next Page
Loading...
Need help?
General
