KYMCO PEOPLE 250 Service Manual

13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
13-20
PEOPL E 25 0
FUEL PUMP INSTALLATION
Install the fuel pump and secure it with the
two nuts.
Connect the fuel pump inlet, outlet and
vacuum tubes.
Install the met-in box and carrier.
Install the body cover, center cover and rear
fender A.
Measure the fuel pump output.
Start the engine and disconnect the fuel outlet
tube and place a clean container under the
tube to check the fuel output.
Output: 40cc/1700rpm/10 seconds .
FUEL TANK REMOVAL
Remove the floor board. (
!
2-7)
Remove four nuts at the tank shield and
remove the tank shield.
Container
Fuel Pump
Outlet Tube
Outlet Tube
Vacuum Tube
Inlet Tube
Nuts
Nuts
Tank Shield

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm