KYMCO PEOPLE 250 Service Manual

8. DRIVE AND DRIVEN PULLEYS/
V-BELT
8-4
PEOPL E 25 0
Connect the drive belt air tube to frame.
DRIVE PULLEY
DRIVE PULLEY FACE REMOVAL
Remove the left crankcase cover. (
!8-3
)
Hold the drive pulley using a universal holder
and remove the drive face nut and washer.
Remove the drive pulley face.
Universal Holder E017
CLUTCH OUTER/DRIVEN
PULLEY/V-BELT
REMOVAL
Remove the left crankcase cover. (
!
8-3)
Remove the drive pulley face. (
!
8-4)
Hold the clutch outer with the universal
holder and remove the clutch outer nut and
washer.
Universal Holder E017
Remove the clutch outer, driven pulley and
belt together.
Remove the drive belt from the movable drive
face.
INSPECTION
Check the drive belt for cracks, separation or
abnormal or excessive wear.
Measure the drive belt width.
Service Limit: 22.0mm replace if below
Drive Pulley Face
Universal Holder
Movable Drive Face
Drive Belt
Air Tube
• Use specified genuine parts for
replacement.
＊
Special
Special

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm