KYMCO PEOPLE 250 Service Manual

5. ENGINE REMOVAL/INSTALLATION
5-2
PEOPL E 25 0
ENGINE REMOVAL
Drain the coolant. (
!3-9)
Remove the met-in box, carrier. (
!2-6
)
Remove the frame body cover, center cover
and rear fender A together. (
!2-6
)
Remove the exhaust muffler. (
!2-10
)
Disconnect all of the A.C. generator.
Remove the nut to disconnect the starter
motor wire that goes to the starter relay.
Disconnect the secondary air vacuum tube
and fuel pump vacuum tube from inlet pipe.
Disconnect the air inlet hose (v-belt chamber)
from frame.
Loosen the intake manifold band (air cleaner
tube and inlet pipe).
Disconnect the radiator air ventilated tube and
thermosensor wire coupler from thermostat.
Starter Relay
Intake
Manifold
Band
Fuel Pump Vacuum Tube
A.C. Generator Wire Connectors
Nut
Starter Motor Wire
Secondary Air
Vacuum Tube
Air Inlet Hose
(V-belt Chamber)
Inlet Pipe
Thermosensor Wire Coupler
Radiator Air
Ventilated Tube
Thermostat

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm