KYMCO PEOPLE 250 Service Manual

4. LUBRICATION SYSTEM
4-6
PEOPL E 25 0
Screw
Pump
Cover
Install the pump cover by aligning the hole in
the cover with the dowel pin.
Tighten the screw to secure the pump cover.
Make sure that the pump shaft rotates freely
without binding.
OIL PUMP INSTALLATION
Install the oil pump and oil separator and
tighten the two bolts.
Make sure that the pump shaft rotates freely.
The arrow of oil pump is upside.
Install the pump drive chain and driven gear,
then set the circlip securely on the pump
shaft.
Install the oil separator cover properly.
Install the A.C. generator starter driven gear.
(
!
10-8)
Dowel Pin
Hole
Arrow Mark
Oil Pump
Bolts
Circlip
Oil Pump Driven Gear
Oil Pump Drive chain
Bolts
Oil Separator Cover
Pump Shaft
Fit the tab of the separator cover into the
slit in the separator.
＊

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm