KYMCO PEOPLE 250 Service Manual

14.STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
14-4
PEOPL E 25 0
STEERING HANDLEBAR
REMOVAL
Remove the handlebar front and rear covers.
(
!
2-3)
Remove the front and rear brake master
cylinder attaching bolts.
Remove the four screws attaching the right
and left handlebar switches.
Disconnect the throttle cable from the throttle
grip and remove the throttle grip from the
handlebar.
Remove the handlebar lock nut then take out
the bolt and collar.
Remove the handlebar.
INSTALLATION
Install the handlebar onto the steering stem
and install the handlebar collar, lock nut and
bolt.
Tighten the bolt to the specified torque.
Torque: 40_ 50N-m
Brake Master Cylinders
Screws
Bolts
Collar
Throttle Grip
Throttle Cable
Bolt
Lock Nut

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm