KYMCO PEOPLE 250 Service Manual

18. STARTING SYSTEM
18-3
PEOPL E 25 0
STARTER MOTOR
REMOVAL
Remove the seat, met-in box and carrier. (
!
2-
6)
Remove the body cover, center cover and rear
fender A together. (
!
2-6)
Remove the nut goes to the starter relay and
relax cable band to disconnect the starter
motor cable.
Remove the two starter motor mounting bolts
and the motor.
DISASSEMBLY
Remove the two starter motor case screws,
front cover, rear cover, motor case and other
parts.
INSPECTION
Inspect the removed parts for wear, damage
or discoloration. Replace if necessary.
Clean the commutator if there is metal
powder between the segments.
AC 110V
Nut
• Before removing the starter motor, turn
the ignition switch OFF and remove
the battery ground. Then, turn on the
ignition switch and push the starter
button to see if the starter motor
operates properly.
＊
Starter Motor Cable
Band
Bolts
Motor Case
Rear Cover
Front Cover
Case Screws
Commutator

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm