KYMCO PEOPLE 250 Service Manual

6. CYLINDER HEAD/VALVES
6-6
PEOPL E 25 0
CAMSHAFT HOLDER DISASSEMBLY
Remove the valve rocker arms.
CAMSHAFT HOLDER INSPECTION
Inspect the camshaft holder, valve rocker
arms and rocker arm shafts for wear or
damage.
Measure the I.D. of each valve rocker arm.
Service Limits: IN: 10.10mm replace if over
EX: 10.10mm replace if over
Measure each rocker arm shaft O.D.
Service Limits: IN: 9.90mm replace if below
EX: 9.90mm replace if below
CYLINDER HEAD REMOVAL
First drain the coolant from the radiator and
water jacket, then remove the thermostat
water hose.
Remove the camshaft. (
!
6-4)
Remove the carburetor and intake manifold.
Remove the bolt attaching the thermostat
housing and the thermostat housing.
Remove the cylinder head.
Bolt
Camshaft Holder
Rocker Arm Shafts
Valve Rocker Arms
Rocker Arm Shafts
Thermostat
If the valve rocker arm contact surface is
worn, check each cam lobe for wear or
damage.
＊

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm