KYMCO PEOPLE 250 Service Manual

3. INSPECTION/ADJUSTMENT
3-9
PEOPL E 25 0
HEADLIGHT AIM
Turn the ignition switch ON.
Turn on the headlight switch.
Adjust the headlight aim by turning the
headlight aim adjusting bolt.
CLUTCH SHOE WEAR
Start the engine and check the clutch
operation by increasing the engine speed
gradually.
If the motorcycle tends to creep or the engine
stalls, check the clutch shoes for wear and
replace if necessary.
COOLING SYSTEM
COOLANT LEVEL INSPECTION
Place the scooter on its main stand on level
ground.
Check the coolant level of the reserve tank
and the level should be between the upper
and lower level lines.
If necessary, remove the screw and reserve
tank cover to fill the reserve tank with
recommended coolant to the “F” level line.
Recommended Coolant: SIGMA Coolant
(Standard Concentration 30%)
COOLANT REPLACEMENT
Lower Line
Headlight Aim Adjusting Bolt
Upper Line
Reserve Tank Cover
Screw
• The coolant level does not change no
matter the engine is warm or cold. Fill
to the “F” (upper) line.
＊
• Perform this operation when the engine
is cold.
＊

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm