EasyManuals Logo

KYMCO PEOPLE 250 Service Manual

KYMCO PEOPLE 250
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
3. INSPECTION/ADJUSTMENT
3-7
PEOPL E 25 0
CYLINDER COMPRESSION
Warm up the engine before compression test.
Remove the center cover and spark plug cap.
Remove the spark plug.
Insert a compression gauge.
Open the throttle valves fully and pushes the
starter button to test the compression.
Compression: 15±2kg/cm_
If the compression is low, check for the
following:
_Leaky valves
_Valve clearance to small
_Leaking cylinder head gasket
_Worn pistons
_Worn piston/cylinder
If the compression is high, it indicates that
carbon deposits have accumulated on the
combustion chamber and the piston head.
FUEL TANK CAP CABLE WIRE
Please remove the front cover to inspect the
fuel tank cap cable wire slack when operate
the fuel tank cap hardly.
SEAT CABLE WIRE
Please remove the front cover to inspect the
seat cable wire when operate the seat hardly.
Compression Gauge
Relax
Pull
Pull
Relax
Look Nut
Adjust Nut
Adjust Nut
Look Nut

Table of Contents

Other manuals for KYMCO PEOPLE 250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KYMCO PEOPLE 250 and is the answer not in the manual?

KYMCO PEOPLE 250 Specifications

General IconGeneral
Displacement249 cc
Fuel SystemElectronic Fuel Injection
Front SuspensionTelescopic fork
Front BrakeDisc
Rear BrakeDisc
Front Tire110/70-16
Rear Tire140/70-16
TransmissionCVT
Seat Height800 mm
Width780 mm

Related product manuals