KYMCO PEOPLE 250 Service Manual

3. INSPECTION/ADJUSTMENT
3-8
PEOPL E 25 0
FINAL REDUCTION GEAR OIL
Stop the engine and remove the oil checks
bolt.
The oil level shall be at the oil check
blowhole.
If the oil level is low, add the recommended
oil SAE90# to the proper level.
Install the oil check bolt.
GEAR OIL CHANGE
Remove the oil check bolt.
Removes the oil drains bolt and drain the oil
thoroughly.
Install the oil drain bolt.
Torque: 9.8N-m
Fill the final reduction with the recommended
oil SAE90#.
Gear Oil Capacity:
At disassembly : 230cc
At change : 180cc
Reinstall the oil check bolt and check for oil
leaks.
DRIVE BELT
Remove the left crankcase cover.
Inspect the drive belt for cracks or excessive
wear.
Replace the drive belt with a new one if
necessary and in accordance with the
Maintenance Schedule.
Drive Belt
Oil Check Bolt Hole/Oil Filler
• Place the scooter on its main stand on
level ground.
＊
Oil Drain Bolt/Sealing
Washer
• Make sure that the sealing washer is in
good condition.
＊
• Make sure that the sealing washer is in
good condition.
＊

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm