KYMCO PEOPLE 250 Service Manual

19. SWITCHES/HORN/FUEL UNIT/THERMOSTATIC SWITCH
/TEMPERATURE GAUGE/INSTRUMENTS/LIGHTS
19-8
PEOPL E 25 0
FRONT POSITION LIGHT
/HEADLIGHT BULB
REPLACEMENT
Remove the handlebar front cover. (
!
2-3)
Remove the bulb socket by turning them
counterclockwise.
Remove the bulb and replace with new one.
Disconnect the headlight wire couplers.
Remove the rubber boot from the bulb socket.
Relax the lock clip to remove the bulb and
replace with new one.
Install the bulb, aligning the bulb socket tab
with the groove and set the lock clip.
Install the rubber boot.
Install the handlebar front cover in the reverse
order of removal.
TAILLIGHT LIGHT BULB EPLACEMENT
Remove the two screws attaching the rear
light shell and remove the light shell.
Remove the bulb and replace with new ones.
The installation sequence is the reverse of
removal.
SIDE STAND SWITCH
Color
Position
Yellow/
Green
Green
Yellow/
Black
DOWN
○
○
UP
○
○
Screws
Front Position Light Bulb
Sockets
Bulb Socket
Rubber Boot
Bulb
Front Position Light Bulb Socket
Side Stand Switch
Side Stand Switch

KYMCO PEOPLE 250 Specifications

General

Displacement	249 cc
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Front Tire	110/70-16
Rear Tire	140/70-16
Transmission	CVT
Seat Height	800 mm
Width	780 mm