MIMAKI APC-130 User Manual

Warning/Error Messages
4-6
Warning Messages
These are the message displayed in the remote mode.
As this does not indicate the device breakdown, take the proper measure as required.
Messages Cause Solution
The remote mode is selected.
When you press the key, the
screen returns to LOCAL.
The received data capacity is
displayed.
When you start cutting (plotting), it will
decrease by 1KB step.
As the cut data exceeds the available
cutting area, the device stops after
cutting up to the sheet end.
Set a new sheet, or make data
smaller.
The clamp lever was operated without
the sheet set.
After setting the sheet, operate the
clamp lever.
The not ready mode (NR;) from the
host computer was received, and the
device is in the local mode.
After performing the required
operation such as the sheet detection
and the origin detection, press the
key to enter into the remote
mode.
The digitizing command (DP;) from
the host computer was received, and
the device is in the digitizing mode.
Move the pen tip as required and
press the key.
To release the digitizing mode, press
the key to perform data
clear. ( P.2-25)
CUT 1 * REMOTE *
CUT 1 * 1 2 8KB *
** OFFSCALE **
** NO SHEET **
** VIEW **
* * DIGITIZE * *

MIMAKI APC-130 Specifications

General

Brand	MIMAKI
Model	APC-130
Category	Plotter
Language	English