MIMAKI APC-130 User Manual

3-18
8
Repeat the procedures of the Step 6 and 7 to set other
setting items.
• Perform the same operations as in Steps 6 and 7 to set all items.
9
Press the key.
10
Press the key several times to end the setting.
Setting the Device No.
Sets the recognition number of the device when you connect two of this device with one computer via USB.
1
Press the key in LOCAL mode.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [DEVICE No.] .
5
Press the key.
6
Press to select the recognition number of
the device.
• Setting value : 00 to 99
7
Press the key.
8
Press the key several times to end the setting.
• The set value is retained even when the power is turned "OFF".
• The set value is retained even when the power is turned "OFF".
SQUARE CUT <ENT >
SET UP <ENT>
COMMAND < e n t >
DEV I CE No . < e n t >
DEV I CE No . : 0
DEV I CE No . : 1 0

MIMAKI APC-130 Specifications

General

Brand	MIMAKI
Model	APC-130
Category	Plotter
Language	English