3-6
Perform Multiple Cutting (plotting)
Already received data can be copied (plotted with a pen) to produce a multiple number of pieces of data. (Up to
999 pieces)
1
Press the key in LOCAL mode.
2
Check the origin position. ( P.2-22)
• When you copy after cutting in the remote mode, cutting (plotting)
are overlapped. Be sure to set the origin again.
3
Press to select [COPY].
4
Press the key.
5
Press to select the number of pieces of
data (1 to 999) produced by copying data.
6
Press the key.
• Starts the cutting (plotting) by the set number.
• [The number of copies currently performed/ the set number] is
displayed on the screen.
• When copy is completed, the device moves to the remote mode.
• Copying of data to produce a multiple number of pieces of data is performed with the data stored in
the machine's reception buffer being specified.
• Only one piece of data can be stored in the reception buffer.
• When new data is received, it is overwritten on the data that has been stored in the buffer.
(The previously received data cannot be specified for it to be copied to produce a multiple number of
pieces of data.)
• The data sent from the computer during copying is ignored.
• While the axial correction of two positions has been set, if the origin updated in this device is not in the
available cut area, the data is not cut.
• Depending on your cutting software, automatic cutting is not performed even if the automatic cutting
is set in this device. If you use the copy function in such a case, as the origin is not updated
automatically, cutting is performed on the same position.
To Next Page
Loading...
Need help?
General
