Cine Review
12-4
12.7 Cine Setup
12.7.1 Setting Cine Length
You can set the cine length in the system setup screen. Enter the system setup screen,
and open the [General] page. In the Storage field, the Cine Length item is located in the
middle, as shown in the figure below.
For Time without ECG (s), the unit is second (s), and it refers to the duration from the
moment of freezing counted down to the set time point.
For Time (ECG Loop), the unit is number of cardiac cycles, which can only be selected
through the drop-down menu. The cardiac cycles can be selected in the range between 1
and 16.
12.7.2 Setting Cine Memory Split
You can set the cine memory split through the path Setup → System → Image Preset.
Select Auto or Split for Cine Memory in the Image Preset page.
“Auto” for the cine memory indicates the system splits the cine memory as per the number
of B image windows; “Split” indicates the system always splits the cine memory, even if in
the single-B window, the system splits the cine memory into two as well. You can press
the [B] key to switch and display the images in either memory, so you can compare
images in “Split”. The memory capacity is evenly distributed as per splitting number, as
shown in the following table (Taking B images in low density as an example, the capacity
of B cine memory is N frames):
Single-B Dual Quad
Auto
One memory, with
capacity N frames
The memory splits
into two, with
capacity N/2
frames each
The memory splits
into four, with
capacity N/4 frames
each
Split
The memory
splits into two,
with capacity N/2
frames each
The memory splits
into two, with
capacity N/2
frames each
The memory splits
into four, with
capacity N/4 frames
each
Ima
To Next Page
Loading...
Need help?
General
