Exam Preparation
8-8
8.3 Pause Exam & Continue Exam
8.3.1 Pause Exam
1. Sometimes, you have to stop an uncompleted exam due to some special causes.
When the exam is paused, the system can begin other exams.
Procedures:
a) Press the <Info> key to open the Patient Info screen.
b) Click [Pause Exam].
2. If the system is powered off during scanning, the exam status turns "paused" after the
system restart.
When an exam is paused, the system will do the followings:
z Saves the exam-related images, reports and measurement data, modifies the
status as “Paused”.
z Save the exam information, including report, imaging mode, exam mode, image
parameters, operation mode, imaging / measurement data and so on.
8.3.2 Continue Exam
Select an exam that is paused within 24 hours, click [Continue Exam] in iStation or
Review screen to continue the exam.
If you want to select a patient data in an external memory database, you have to first allow
the system to load the patient data to the system’s patient database.
Specific operation:
1. Enter the iStation screen.
2. Select items to be recovered in the list.
3. Click [Continue Exam] and restore the exam.
8.4 End Exam
Before examining a new patient, press <End Exam> to end the exam of the previous
patient, update the patient ID and information, to avoid mixing data of the next new
patient.
To end an exam, you can do one of the following:
z Press <End Exam> on the control panel.
z Click [New Patient] on the Patient Info screen to end the last patient exam and
clear the patient information.
z Click [New Exam] on the Patient Info screen (or iStation screen, or Review screen)
to end the last exam and clear the exam data.
To Next Page
Loading...
Need help?
General
