Mitsubishi FX3U-16CCL-M User Manual

8 Parameter Setting
82
FX3U-16CCL-M User's Manual
8.3 Parameter Setting from Sequence Program
8.3 Parameter Setting from Sequence Program
This section explains the parameter setting within the sequence program.
Caution
The auxiliary relays in the non-keep area must be used as auxiliary relays (M) for parameter setting
programs. For details, refer to Section 11.1.
Parameter setting program
M0PLS
M1SET
M8000
Unit error
M20
M35
RUN monitor
Unit ready
M1
M1
Only when
required
Number of automatic
return units
Number of retries
Mode
BFM#10
M35 to M20
Error invalid station
specification
M0
Number of connected units
FNC 79
FROM
K0 K10 K4M20 K1
Operation specification
when CPU is down
FNC 12
MOV
D0
FNC 12
MOV
D1
FNC 12
MOV
D2
FNC 12
MOV
D3
FNC 78
TO
K0 K0 D0 K4
FNC 12
MOV
D4
FNC 78
TO
K0 K6 D4 K1
Data link disorder station
setting
FNC 12
MOV
D5
FNC 78
TO
K0 K16 D7 K1
Case of CPU STOP setting
FNC 12
MOV
D6
FNC 78
TO
K0 K12 D5 K2
Reserved station
specification
FNC 12
MOV
D7
FNC 12
MOV
D8
FNC 78
TO
K0 K20 D8 K1
Writes the mode, number of
connected units, number of
retries and number of
automatic return units
Writes the operation
specification when CPU is
down
Writes the Data link disorde
r
station setting and Case of
CPU STOP setting
Writes the Reserved station
specification
Writes the Error invalid
station specification

Mitsubishi FX3U-16CCL-M Specifications

General

Brand	Mitsubishi
Model	FX3U-16CCL-M
Category	Controller
Language	English