Oki MB770dn User Manual

SETTING N/W-Fax DRIVER
- 151 -
2
1
3
4
5
6
7
9) Message
Check this to have a message appear on the cover sheet.
You can enter the message in up to 500 characters.
10) [Restore Defaults]
Click this to restore the default setting values.
Setting up the SNMP
If the recipient’s MFP is not found over the Internet and the fax
job is not sent normally, the SNMP settings may be the cause.
Check that the SNMP settings are correct in the [SNMP
Settings] dialog box, and if not, change them.
Note
• Ask the administrator for details on the SNMP Network
settings configured for your MFP.
1) Version
Be sure to have the correct SNMP version set for your MFP
and select from the following options:
- V1/V2 — Select this option to enable SNMP V1 and V2.
- V3 — Select this option to enable SNMP V3.
- V1/V2/V3 (for [Discovery Settings] dialog box only)
— Select this option to enable SNMP V1, V2, and V3.
2) SNMP V1/V2
Community Name — If a community name other than
“private” (default) is set for the SNMP community name for
your machine, enter its community name.
Note
• To send fax jobs normally under an SNMP V1/V2
environment, the SNMP community names must be the
same in the 3 settings shown below.
- Your machine
- [SNMP Settings] dialog box of the [Sender
Information] tab
- TCP/IP port of the [Ports] tab in the N/W-Fax driver
• To change the community name, the administrator
privilege is necessary. You must log in with the
“Administrator” privilege and open the printer driver
properties.
• Up to 31 characters including the following symbols can
be entered for the Community Name.
! " # $ % & ' ( ) * + , - / : ; < = > ? @ [ \ ] ^ _ ` { | } ~
1
2
3
4

Oki MB770dn Specifications

General

Brand	Oki
Model	MB770dn
Category	All in One Printer
Language	English