SETTING ITEMS (ADMIN)
- 287 -
5
Confirm the settings and press [APPLY
NOW].
“NETWORK INITIALIZING” is displayed at the lower left
of the screen and this equipment starts initializing the
network interface card to apply the changes. This
message disappears when the setting is complete.
Error messages
The following error messages may be displayed on the touch
panel.
Message Cause
[802.1X] Auth Server/Switch
couldn’t be contacted
• The RADIUS server
service is stopped.
• Configuration for the
RADIUS server is not
correct.
• The IEEE 802.1X switch
has problem.
[802.1X] Authentication failed • The username or
password that the user
entered is not correct.
• The certificates uploaded
are wrong.
Certificate verification Failure • A CA certificate is not
installed in the
equipment.
• The installed CA
certificate is not valid.
• The server certificate is
invalid.
To Next Page
Loading...
Need help?
General
