SETTING ITEMS (ADMIN)
- 283 -
1
Press [NONE] and press [NEXT].
The TRANSMIT POWER SETTINGS screen is displayed.
2
Select the transmit power and press [NEXT]
button.
Select the low transmit power if you want to limit the area
that the wireless communication is enabled. If you do not
have to limit the area, select [100%].
3
Confirm the settings and press [FINISH]
button.
Memo
• If you want to change the settings, press [PREV] to
move back to the screen that you want to change and
then repeat the operation.
4
Press [YES], and wait until the setting is
reflected.
Disabling Wireless Network
When you enable the wireless network, the on-board NIC
(Network Interface Card) will be disabled.
If you want to connect the equipment to wired network via the
on-board NIC, you must disable the wireless network.
1
Press [SETTING] button on the control
panel to enter the SETTING menu.
2
Press [ADMIN].
The ADMINISTRATOR PASSWORD screen is displayed.
3
Press [PASSWORD] button.
The input screen is displayed.
4
Enter the administrator password and
press [OK].
The ADMIN menu is displayed.
To Next Page
Loading...
Need help?
General
