Getting Started with Servicing the Hardware
TABLE 6
Additional Properties for InfiniBand Host Controller Adapters
Action Description
State
When "active", the active-port icon is displayed.
Other valid port states ("down", "init", and "arm") are
denoted by the inactive-port icon . Mousing over
the port icon will display the current port state in the tip
pop-up.
GUID The hardware assigned port GUID.
Speed The current port speed enabled: Single Data Rate (SDR),
Dual Data Rate (DDR) or Quad Data Rate (QDR)
Service Processor
The service processor behaves differently from other component nodes. Instead of providing
a list of components, it presents a set of network properties that can be configured from the
storage appliance. The following properties control the behavior of the service processor
network management port.
TABLE 7
Properties for the Service Processor Network Management Port
Property Description
MAC Address Hardware MAC address. This is read-only
IP Address Source Either 'DHCP' or 'Static'. Controls whether DHCP should
be used on the interface.
IP Address IPv4 Address, when using static IP configuration. IPv6 is
not supported.
Subnet Dotted decimal subnet, when using static IP
configuration.
Default Gateway IPv4 default gateway address.
Changing multiple values in conflicting ways (such as changing static IP assignments while in
DHCP mode) has undefined behavior.
CLI Hardware View
Hardware status details are available in the CLI under the maintenance hardware section. Use
the show command to list the status of all components. The list command will list available
chassis, which can be selected and then viewed using show.
18 Oracle ZFS Storage Appliance Customer Service Manual • February 2016
To Next Page
Loading...
Need help?
General