EasyManuals Logo
Home>Oracle>Storage>ZFS ZS3 Series

Oracle ZFS ZS3 Series Customer Service Manual

Oracle ZFS ZS3 Series
312 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #260 background imageLoading...
Page #260 background image
How to Replace a Disk Shelf SIM Board
10.
Go to the Maintenance > Hardware section of the BUI, click the right-arrow icon
at the beginning of the appropriate disk shelf row, and then click Slot to verify
that the I/O Module online icon is green for the newly installed I/O Module.
How to Replace a Disk Shelf SIM Board
Caution - Do not remove a component if you do not have an immediate replacement. The disk
shelf must not be operated without all components in place, including filler panels. Refer to
“Disk Shelf Hardware Overview” on page 234 for component locations.
The following disk shelves have SIM boards:
Sun Disk Shelf
The SIM boards, which are similar to I/O Modules, are hot-swappable so you can replace them
without removing power to the system. The SIM boards are multi-pathed, so you can remove
one of the SIM boards at any time, regardless of the state of the blue SIM OK indicator.
1.
A faulted SIM board is indicated by an amber LED. Go to the Maintenance >
Hardware section of the BUI, click the right-arrow icon at the beginning of the
appropriate disk shelf row, and then click Slot to view details, or click the locator
icon to turn on the locator LED.
2.
Locate the failed SIM at the back of the disk tray.
3.
Label and disconnect the tray interface cables.
4.
Use two hands to disconnect the SAS cable. Grasp the metal body of the
connector with one hand and firmly grasp and pull the tab gently toward the
connector body with the other, then pull the connector body outward to extract it
from the bulkhead. Do not twist or pull the tab in any direction other than parallel
with the connector body or it may break. If the tab breaks, use a small sharp
object (such as a fine-tipped screwdriver) to lift the metal spring at the top of the
connector shell to unlatch it.
5.
Loosen the two extraction arm captive screws using your thumb and forefinger.
If the captive screws are too tight to loosen by hand, use a No.2 Phillips
screwdriver to loosen each screw.
260 Oracle ZFS Storage Appliance Customer Service Manual • February 2016

Table of Contents

Other manuals for Oracle ZFS ZS3 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oracle ZFS ZS3 Series and is the answer not in the manual?

Oracle ZFS ZS3 Series Specifications

General IconGeneral
BrandOracle
ModelZFS ZS3 Series
CategoryStorage
LanguageEnglish

Related product manuals