3.44
ENGINE / COOLING
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
19. Once the gears are pressed together, firmly hold the
gears together with one hand. Carefully remove the
Tapered Pins (PU-45497-1) by pulling them out one
at a time with the other hand.
20. After the tapered pins are removed, be sure the cam
g
ear assembly is held together tightly. Place the cam
gear assembly on a flat surface. Use the Cam Gear
Tooth Alignment Tool (PU-45497-2) to align the teeth
of the cam gears, as shown in the picture.
NOTE: Install the Cam Gear Alignment Tool (PU-
4
5497-2) into one assembly hole counter clockwise
from the timing mark.
NOTE: For ease of installing the Cam Gear
Alig
nment Tool (PU-45497-2), use a twisting motion
when pushing down on the tool.
21. To remove the balance shaft gear, the flat side of the
ca
mshaft (P) must face the balance shaft gear. To
rotate the camshaft, use the Cam Spanner Wrench
(PU-45498) to rotate the camshaft so the flat side of
the camshaft faces the balance shaft gear.
NOTE: This Cam Spanner Wrench (PU-45498) is
only nee
ded to rotate the camshaft when the entire
valve train is assembled. If the rocker arms are
removed, the cam-shaft can be turned by hand.
22. Remove the bolt and nut from the balance shaft gear.
T
ry to remove the balance shaft gear. If the gear does
not come off manually, use the Flywheel Puller (PN
2871043) to remove the balance shaft gear.
To Next Page
Loading...
Need help?
General
