Polaris 2013 RANGER RZR S User Manual

3.46
ENGINE / COOLING
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
29. Remove the oil pressure relief. The oil pressure relief
consists of a bolt, washer, spring, and valve (dowel).
Inspect the valve (dowel) for signs of possible
obstructions. Use compressed air to blow out any
debris.
30. Reinstall the valve (dowel chamfered end first). Install
the
spring, washer, and bolt. Torque to specification.
NOTE: Be sure to place the tapered end of the valve
(
dowel) in first. If the valve is installed incorrectly, oil
pressure and oil priming problems will occur.
31. Carefully press the gear off the assembly while
su
pporting the housing assembly.
32. Remove snap ring from the assembly. Place housing
in a
support and press out the bearing/shaft assembly.
33. Place the shaft in a press to remove the bearing.
= T
Oil Pressure Relief Bolt:
22 ± 2 ft-lbs (30 ± 3 Nm)
22 ± 2 ft-lbs
(30 ± 3 Nm).
Chamfer
End First
CAUTION
Wear appropriate safety gear during this
procedure. Protective gloves, clothing and eye
wear are required.
Press Off Gear
Press out shaft
and bearing
assembly.
Bearing
Retaining Ring
Press Off Bearing
PRELIMINARY VERSION

Polaris 2013 RANGER RZR S Specifications

General

Brand	Polaris
Model	2013 RANGER RZR S
Category	Offroad Vehicle
Language	English