Qlogic 8100 Series User Manual

4–Installation in a Linux Environment
Firmware Upgrades
4-22 FE0254601-00 A
7. Under Boot Code, click the download link for the multi-boot image
(Figure 4-15). The multi-boot image contains firmware, BIOS and UEFI
drivers, and the FlasUTIL and EFIUTIL utilities. Make note of the FCoE
firmware version included in the multi-boot image.
Figure 4-15. Download the Multi-boot Image
8. Read the license agreement, and then click Agree.
9. When prompted, select Save to save and extract (unzip) the multi-boot
image to a temporary location on your workstation.
Determining the Installed Firmware Version
You can determine the firmware version the QConvergeConsole, or for advanced
users, sysfs.
Displaying the Firmware Version Using the QConvergeConsole
Use QConvergeConsole GUI or QConvergeConsole CLI to determine the
firmware version of the QLogic adapter installed in the server. For information
about installing and using QConvergeConsole, refer to Installing Software.
To display the adapter firmware version:
1. In the QConvergeConsole main window, locate the QLogic 8100 Series
Adapter in the system tree and select the port.
2. In the General Information tab (Figure 4-16), the firmware version (FCoE
firmware) is listed under Flash Information after the BIOS, FCode, and EFI
version information.
CAUTION!
Do not alter any files or the contents of the compressed multi-boot
image or the extracted files—this is could corrupt the boot code.
Flashing a corrupt boot code, or attempting to update boot code using
a different method than what is described in this section, may render
the adapter inoperable.

Qlogic 8100 Series Specifications

General

Brand	Qlogic
Model	8100 Series
Category	Network Card
Language	English