Qlogic 8100 Series User Manual

8–Configuring FCoE in a Linux Environment
Configuring FCoE Parameters Using QLogic Utilities
8-12 FE0254601-00 A
To configure a parameter from the list of advanced HBA parameters:
1. Expand the port number in the system tree (left pane) of the
QConvergeConsole browser window.
2. Click the FCoE port node.
3. Click the Parameters tab in the right pane.
4. Click the Advanced HBA Parameters subtab, as shown in Figure 8-3.
Figure 8-3. QConvergeConsole Advanced HBA Parameters
Configuring FCoE Driver Parameters Using Fast!UTIL
You can configure most of the adapter FCoE driver parameters using the
Fast!UTIL utility. The application presents the driver parameters as adapter
settings and advanced adapter settings, as shown in Table 8-4.
For information about using the Fast!UTIL BIOS utility, refer to “Fast!UTIL” on
page 9-2. For information about configuring driver parameters on an EFI server,
refer to “EFIUTIL” on page 9-16.

Qlogic 8100 Series Specifications

General

Brand	Qlogic
Model	8100 Series
Category	Network Card
Language	English