7–Configuring FCoE in a Windows Environment
N_Port ID Virtualization
FE0254601-00 A 7-9
7. Select Refresh from the Host drop-down menu and click OK when
prompted to refresh the host.
Verifying the Virtual Ports
Use QConvergeConsole GUI to verify that the vPort has been created:
1. Verify that the vPort is listed in the left pane of the QConvergeConsole
window beneath the FCoE port selected when creating the virtual ports, as
shown in the following example.
Figure 7-3. Verifying Additional Virtual Ports
NOTE:
To benefit from I/O segregation and NPIV monitoring after creating a virtual
port, configure zoning on the FCoE switch, and configure selective LUN
presentation on the Fibre Channel or FCoE target array. For information
about configuring the FCoE switch and target array, refer to the product
documentation
To Next Page
Loading...
Need help?
General