Qlogic 8100 Series User Manual

3–Installation in a Windows Environment
Installing Software
FE0254601-00 A 3-15
Adapter. For information about identifying QLogic devices in the Other
Devices section, refer to “Identifying Unnamed Devices” on page 3-8.
Figure 3-13. QLogic 8100 Series Adapter Device Entries
b. To install the driver, right click Fibre Channel Controller, and then
click Update Driver (Figure 3-14).
Figure 3-14. Installing an FCoE Driver
6. If you are updating QLogic adapter drivers:
a. Click SCSI and RAID Devices (for FCoE Drivers). Find each port of
the QLogic adapter FCoE function that is listed as QLogic FCoE
Adapter under this section. Figure 3-15 shows typical entries for a
dual-port QLogic 8100 Series Adapter.
Figure 3-15. Typical QLogic 8100 Series Adapter Port Entry

Qlogic 8100 Series Specifications

General

Brand	Qlogic
Model	8100 Series
Category	Network Card
Language	English