R&S RTC1000 User Manual

Signal Generation (Option R&S RTC-B6)
R&S
®
RTC1000
114User Manual 1335.7352.02 ─ 02
10 Signal Generation (Option R&S RTC-B6)
The signal generation option R&S RTC-B6 provides a function generator and a pattern
generator. You can find the generator settings in the UTIL menu.
To load a predefined function or pattern
The instrument provides a predefined pattern files for the important functions and pat-
terns.
1. Press the SAVE/RECALL key.
2. Press "DEVICE SETTINGS".
3. Press "LOAD".
4. Use the Universak knob to select one of the predefined patterns (*. SCP files) from
the internal memory.
5. Press "LOAD".
10.1 Function Generator
Using the function generator, you can generate input signals for circuits testing and
other purposes. The generated signal is output at the AUX OUT connector.
1. Press the UTIL key in the Vertical section.
2. Press "FUNCTION GEN".
3. Select the parameters of the generated waveform. The parameters are described
below.
An information box shows a preview of the generated waveform with the selected
parameters.
4. To deactivate the function generator, press "OFF".
FUNCTION
Selects the waveform. The following waveforms can be generated and output at the
AUX OUT connector:
●
DC
●
Sine: Frequency range from 0.1 Hz to 50 kHz
●
Rectangle: Frequency range from 0.1 Hz to 50 kHz
●
Pulse: Frequency range from 0.1 Hz to 10 kHz
●
Triangle: Frequency range from 0.1 Hz to 10 kHz
●
Ramp: Frequency range from 0.1 Hz to 10 kHz
FREQUENCY
Selects the signal frequency. The available range depends on the selected function.
Function Generator

R&S RTC1000 Specifications

General

Brand	R&S
Model	RTC1000
Category	Test Equipment
Language	English