Documenting Results
R&S
®
RTC1000
99User Manual 1335.7352.02 ─ 02
b) Press "DISPLAY". Use the UNIVERSAL knob to select the target reference
waveform.
c) Press "LOAD".
d) In the file manager menu, select the storage, the directory, and the file.
e) Press "LOAD" to read and display the reference.
To import or export references
1. In the "SAVE/RECALL" menu, press "REFERENCES".
2. Press "SOURCE FILE" to select the source file using the UNIVERSAL knob.
3. Press "DEST. PATH" to set the storage location using the UNIVERSAL knob.
4. To change the file name, press "DEST. NAME". Enter the file name.
5. To change the file format, press "DEST. FORMAT".
6. Select the target format. See also Chapter 8.3.1, "Waveform File Formats",
on page 101.
7. Press "IMPORT/EXPORT".
8.3 Waveforms (Traces)
You can store also waveform data without settings to external storage for analysis.
Depending on the selected timebase and the record mode in the "ACQUIRE" menu
(AUTOMATIC, MAX. SAMPLE RATE or MAX. WAVEFORM RATE), the maximum
read-out measurement points varies. To read out the full memory, save the waveform
in stop mode with the maximum sampling rate setting.
To store waveform data to file
1. Connect a USB flash drive.
2. In the "SAVE/RECALL" menu, press "TRACES".
Waveforms (Traces)
To Next Page
Loading...
Need help?
General
