Preface
R&S
®
RTC1000
7User Manual 1335.7352.02 ─ 02
1 Preface
1.1 For Your Safety
The R&S RTC1000 digital oscilloscope is designed for measurements on circuits that
are only indirectly connected to the mains or not connected at all. It is not rated for any
measurement category.
The instrument is intended for use in industrial areas. When used in residential areas,
radio disturbances caused by the instrument can exceed given limits. Additional shield-
ing can be required.
The instrument must be controlled by personnel familiar with the potential risks of mea-
suring electrical quantities. Applicable local or national safety regulations and rules for
the prevention of accidents must be observed.
Safety information is part of the product documentation. It warns you about the poten-
tial dangers and gives instructions how to prevent personal injury or damage caused
by dangerous situations. Safety information is provided as follows:
●
The "Basic Safety Instructions" in different languages are delivered as a printed
brochure with the instrument.
●
Throughout the documentation, safety instructions are provided when you need to
take care during setup or operation.
Risk of injury
The instrument must be used in an appropriate manner to prevent electric shock, per-
sonal injury, fire, or damage:
●
Do not open the instrument casing.
●
Do not use the instrument if the instrument casing, the display or any accessory
are damaged. If you detect or suspect any damage, have the instrument or acces-
sory inspected by qualified service personnel.
●
Do not operate the instrument in wet, damp or explosive atmospheres. Make sure
that the instrument, cables and connectors are completely dry before connecting
the inputs.
●
Do not exceed the voltage limits given in Chapter 2.2.1.1, "Input Connectors",
on page 16.
For Your Safety
To Next Page
Loading...
Need help?
General
