6. When the program has ended normally, the message "Completed" is displayed. If the program has
ended abnormally, an error message shows.
7. Turn the main switch off and on.
8. Adjust the printer and scanner registration and magnification ( p.141 "Copy Adjustments Printing/
Scanning").
9. Refer to the SMC lists, and enter any values that differ from the factory settings. Double-check the
values for SP 4901.
10. Adjust the standard white level (SP 4428).
11. Initialize the TD sensor (SP 2214).
12. Check the copy quality and the paper path.
Input Check (SP 5803)
- Conducting an Input Check -
1. Select SP 5803.
2. Select the number (see the table below) corresponding to the component.
3. Select "Execute." The copy mode is activated.
4. The sign "01H" or "00H" show (see the table below).
- Input Check Table -
Num. Sensor/Switch 01H 00H
001 Safety SW Open Closed
002 Safety SW-LD 5V Open Closed
003 Right Cover SW Open Closed
004 Right Low Cover SW Open Closed
005 Tray Cover SW Open Closed
006 Upper Relay S Paper detected Not detected
007 Lower Relay S Paper detected Not detected
008 Vertical Trans S Paper detected Not detected
009 Registration Sensor Paper detected Not detected
010 Exit Sensor Paper detected Not detected
Using SP Modes
155
To Next Page
Loading...
Need help?
General
