SP5-XXX (Mode)
5001 All Indicators On
5001 1
All LEDs turn on. The LCD turns on or off every 3 seconds. Press the reset key to end this
program.
5045* [Accounting count]
[0 to 1 / 1 / -]
0: Developments, 1: Pages
5045 1 Selects the counting method to either developments or prints.
5104* A3/DLT Double Count
[0 = Enabled / 1 = Disabled /
2 = Disabled if the size is undetected]
5104 1
Selects whether the machine counts twice for each sheet of A3/11"x 17". If this is set to
"Yes" is selected, the total (mechanical) counter and the current user counter will both
increment by two for each A3/11" x 17" sheet.
5113* Optional Counter Type
0: None
11: MF key card (Increment)
12: MF key card (Decrement)
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120* Clr-OP Count Remv [0=Yes / 1=Standby only / 2=No]
5120 1
Determines under which conditions the copy job settings are reset when the key counter is
removed. With 0, the settings are cleared if the counter is removed at the end of a job or
midway through a job. With 1, they are only cleared if the counter is removed at the end
of a job. With 2, they are not cleared at all, under either condition. With duplex copies,
the job settings are always preserved, regardless of the setting of this SP mode.
5121* Count Up Timing [0 = Feed In / 1 = Exit]
5121 1
Selects whether the key counter increments at time of paper feed-in or at time of paper
exit.
5127* APS Mode [0 = Enabled / 1 = Disabled]
3. Appendix: SP Mode Tables
38
To Next Page
Loading...
Need help?
General
