Bit Switches
SM 77 D649
Fax Option
Type C305
(D649)
I-fax Switch 01 (SP No. 1-102-002)
No Function Comments
Original Line Resolution of TX
Attachment File
These settings set the maximum resolution of
the original that the destination can receive.
0 200x100 Standard
0: Not selected
1: Selected
If more than one of these three bits is set to "1",
the higher resolution has priority. For example,
if both Bit 0 and Bit 2 are set to "1" Then The
Resolution is set for "Bit 2 200 x 400.
1 200x200 Detail
2 200x400 Fine
3 300 x 300 Reserve
4 400 x 400 Super Fine
5 600 x 600 Reserve
6 Reserve
7 mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail.
There is no switch for converting inches to millimeters.
Unlike G3 fax transmissions which can negotiate between sender and receiver to
determine the setting, mail cannot negotiate between terminals; the mm/inch
selection is determined by the sender fax.
When this switch is Off (0):
 Images scanned in inches are sent in inches.
 Images scanned in mm are sent in mm.
 Images received in inches are transmitted in inches.
 Images received in mm are transmitted in mm.
When this switch is On (1):
 Images scanned in inches are sent in inches.
 Images scanned in mm are converted to inches.
 Images received in inches are transmitted in inches.
 Images received in mm are converted to inches.
To Next Page
Loading...
Need help?
General
