Controller Options
D117/D118 2-106 SM
2. Install the gigabit Ethernet LAN board [A] (Knob [B] x 2) into the board slot.
3. Install the Ethernet connector and USB type B connector cover included in the Gigabit
Ethernet board kit on the 100M bit LAN connector [C] and the USB connector type B [D].
4. Attach the ferrite core [A] (included in the kit) to the Ethernet cable of the gigabit ethernet LAN
card as shown above.
5. Check the operation of the Gigabit Ethernet
2.14.12 CHECK ALL CONNECTIONS
1. Plug in the power cord. Then turn on the main switch.
2. Enter the printer user mode. Then print the configuration page.
User Tools
Printer Settings List Test Print Config. Page
All installed options are shown in the "System Reference" column.
To Next Page
Loading...
Need help?
General
