TC35i AT Command Set
4.12 AT^STPB
s
m
obil
e
TC35i_ATC_V02.07 Page 107 of 439 1/30/04
Confidential / Released
4.12 AT^STPB Transmit Parity Bit (for 7E1 and 7O1 only)
This command is intended only for use with 7E1 and 7O1. In addition to the 7E1 or 7O1 settings made with
AT+ICF the command AT^STPB specifies whether or not to transmit the parity bit over the air.
Syntax
Command Description
The test command returns the supported values of the parameter <n>.
The read command returns the current value of the parameter <n>.
The write command can be used to control the handling of the parity bit. If command fails, "+CME ERROR:
unknown" will be returned.
Test Command
AT^STPB=?
Response(s)
^STPB: (list of supported <n>s)
OK
Read Command
AT^STPB?
Response(s)
^STPB: <n>
OK
Write Command
AT^STPB=<n>
Response(s)
OK
ERROR
+CME ERROR: unknown
PIN ASC0 MUX1 MUX2 MUX3
! % % ! !
Reference(s)
SIEMENS
To Next Page
Loading...
Need help?
General
