TC35i AT Command Set
11.20 AT^SCMS
s
m
obil
e
TC35i_ATC_V02.07 Page 312 of 439 1/30/04
Confidential / Released
11.20 AT^SCMS Send concatenated SMS messages
Sending a concatenated message is similar to sending a "normal" message, except that each segment of the
concatenated message must be identified by the additional parameters
<seq>, <ieia> and <ref>. To send all
segments of the message one by one, the
AT^SCMS write command must be executed for each segment.
Syntax
Command Description
The write command transmits one segment of a concatenated short message from TE to network (SMS-SUB-
MIT).
After invoking the write command wait for the prompt ">" and then start to write the message. To send the mes-
sage simply enter
<CTRL-Z>. After the prompt a timer will be started to observe the input.
To abort sending use
<ESC>. Abortion is acknowledged with "OK", though the message will not be sent.
The message reference
<mr> is returned to the TE on successful message delivery. The value can be used to
identify the message in a delivery status report provided as an unsolicited result code.
Notes
• See notes provided for AT+CMGS.
• Command is only available if
AT+CMGF=1.
Test Command
AT^SCMS=?
Response(s)
OK
Write Command
Command syntax for text mode (see AT+CMGF=1):
AT^SCMS=<da>[, <toda>], <seq>, <max>, <ieia>, <ref><CR> Text can be entered <CTRL-Z>/<ESC>
Response(s)
+CMGS: <mr>[, <scts>]
OK
If sending fails
ERROR
+CMS ERROR
PIN ASC0 MUX1 MUX2 MUX3
% % % % %
Reference(s)
SIEMENS
To Next Page
Loading...
Need help?
General
