Siemens TC35i Terminal User Manual

TC35i AT Command Set
7.10 AT^SHUP
s
m obil e
TC35i_ATC_V02.07 Page 156 of 439 1/30/04
Confidential / Released
7.10 AT^SHUP Hang up call(s) indicating a specific GSM04.08 release
cause
Syntax
Command Description
The write command serves to end one specific call or all calls known to the ME, indicating a specific GSM04.08
release cause specified by the user. The command can be used for voice, fax and data calls in any call status
(i.e. any calls listed by
AT+CLCC).
Parameter Description
release cause
Release cause from GSM04.08 to be indicated to the network.
The TC35i will release the selected connection(s) with release cause indication "cause" and location "user" (0)
in the "disconnect" protocol message to the GSM Network. It depends on the network whether or not the release
cause will be forwarded to the remote party.
1 send GSM04.08 release cause "unassigned (unallocated) number"
16 send GSM04.08 release cause "Normal call clearing "
17 send GSM04.08 release cause "User busy "
18 send GSM04.08 release cause "No user responding "
27 send GSM04.08 release cause "Destination out of order "
31 send GSM04.08 release cause "Normal, unspecified"
Test Command
AT^SHUP=?
Response(s)
OK
Write Command
AT^SHUP=<cause>[, <cn>]
Response(s)
ERROR
OK
PIN ASC0 MUX1 MUX2 MUX3
% % % % %
Reference(s)
Siemens
<cause>
(num)

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English