Siemens TC35i Terminal User Manual

TC35i AT Command Set
7.11 ATS0
s
m obil e
TC35i_ATC_V02.07 Page 158 of 439 1/30/04
Confidential / Released
7.11 ATS0 Set number of rings before automatically answering the
call
Syntax
Command Description
This parameter setting determines the number of rings before automatic answering.
Parameter Description
000
(&F)
automatic answering is disabled
001-255 enable automatic answering on the specified ring number
Notes
• This command works for MT data, fax and voice calls.
• Autoanswering of CSD data and fax calls is supported on ASC0/Mux1 only.
• If
<n> is set to higher values, the calling party may terminate the call establishment before the call can be
automatically answered.
• The correlation between
ATS7 and ATS0 is important.
Example: ATS7=30 and ATS0=20 may not allow call establishment.
• Setting is local to the interface. It is allowed to have different settings on different interfaces. In such cases
the interface 'wins', which is idle and uses the smallest
<n> value.
Read Command
ATS0?
Response(s)
<n>
OK
Write Command
ATS0=<n>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
V.25ter
<n>
(num)(&W)(&V)

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English