Siemens TC35i Terminal User Manual

TC35i AT Command Set
2.9 AT+CFUN
s
m obil e
TC35i_ATC_V02.07 Page 42 of 439 1/30/04
Confidential / Released
EXAMPLE 2
To set the ME to NON-CYCLIC SLEEP mode enter
When, for example, an SMS is being received and indicated by an unsolicited result code (URC), the ME
wakes up to full operation.
Note that the URC used in this example will appear only, if
AT+CNMI=1,1 was configured before.
After this, you may want to verify the operating status:
EXAMPLE 3
To stop CYCLIC SLEEP mode and return to full functionality:
Remember that this approach is not applicable to the NON-CYCLIC SLEEP mode (since the serial interface
is disabled). The NON-CYCLIC SLEEP mode ends with the first wake-up event.
EXAMPLE 4
To reset and restart the ME:
2.9.1 Wake up the ME from SLEEP mode
A wake-up event is any event that switches off the SLEEP mode and causes the ME to return to full functionality.
In short, it takes the ME back to
AT+CFUN=1.
Definitions of the state transitions described in the table below:
• Yes means: ME exits SLEEP mode
• No means: ME does not exit SLEEP mode
AT+CFUN=0
OK
+CMTI: "SM",5
AT+CFUN?
+CFUN: 1 Indicates that ME has entered full functionality mode.
AT+CFUN?
+CFUN: 5
OK
AT+CFUN=1
OK
AT+CFUN=1,1 or alternatively, AT+CFUN=0,1 or 5,1 or 6,1 or 7,1 or 8,1
OK
^SYSSTART The ^SYSSTART URC confirms that the ME has been rebooted. Note
that ^SYSSTART appears only if
AT+IPR ¹ 0. If the ME is in autobaud
mode, it is recommended to wait 3 to 5 seconds before entering the first
AT command. Remember to enter the SIM PIN after restart.
Event From <fun>=0 to
<fun>=1
From <fun>=5 or 6 to
<fun>=1
From <fun>=7 or 8 to
<fun>=1
Ignition line No No No
/RTS0 Yes No No

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English