Siemens TC35i Terminal User Manual

TC35i AT Command Set
7.8 ATH
s
m obil e
TC35i_ATC_V02.07 Page 154 of 439 1/30/04
Confidential / Released
7.8 ATH Disconnect existing connection
Syntax
Command Description
Disconnect existing call from command line by local TE and terminate call.
Parameter Description
[0] disconnect from line and terminate call
Notes
• OK is issued after circuit 109 (DCD) is turned off, if it was previously on.
•
ATH terminates every circuit switched call (voice, data or fax), even if it is issued via another interface. This
behavior is in accordance with ITU-T V.25 ter; (07/97, "Hook control": "
ATH is terminating any call in
progress.").
Exec Command
ATH[<n>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
V.25ter
<n>
(num)

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English