Siemens TC35i Terminal User Manual

TC35i AT Command Set
4.8 AT+IFC
s
m obil e
TC35i_ATC_V02.07 Page 96 of 439 1/30/04
Confidential / Released
4.8 AT+IFC Set Flow Control separately for data directions
The command AT+IFC can be used to set or query the data flow control separately for each data direction.
Syntax
Command Description
The test command returns the values of the supported methods of flow control.
The read command returns the currently selected methods of flow control.
The write command determines the data flow control on the serial interface.
Parameter Description
Specifies the method used by the TE when receiving data from the TA.
[0] none
Test Command
AT+IFC=?
Response(s)
+IFC: (list of supported <TEflowcontrol>s), (list of supported <TAflowcontrol>s)
OK
Read Command
AT+IFC?
Response(s)
+IFC: <TEflowcontrol>, <TAflowcontrol>
OK
Write Command
AT+IFC=<TEflowcontrol>, <TAflowcontrol>
Response(s)
OK
ERROR
PIN ASC0 MUX1 MUX2 MUX3
! % § § §
Reference(s)
V.25ter
<TEflowcontrol>
(num)(&W)

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English