TC35i AT Command Set
4.8 AT+IFC
s
m
obil
e
TC35i_ATC_V02.07 Page 97 of 439 1/30/04
Confidential / Released
1 XON/XOFF, terminate flow control in the Cellular Engine
2RTS line
3 XON/XOFF, evaluate flow control in the Cellular Engine and pass it through
(over the air) to the opposite TE
Specifies the method used by the TA when receiving data from the TE.
[0] none
1 XON/XOFF
2CTS line
Notes
• Flow control settings made with AT\Q are valid in both data directions.
• When using XON/XOFF flow control ( AT+IFC =1,x or AT+IFC =3,x) in data mode,
+++ should not be used
while the data transmission is paused with XOFF. Before entering the command mode with
+++ the paused
transmission should be resumed using the XON character.
• For compatibility reasons, the
AT+IFC command can be used in Multiplex mode, though the settings will not
take effect. However, be aware that whenever you use the
AT+IFC write command in Multiplex mode and
then save the current configuration to the user profile with
AT&W, the changed AT+IFC setting will become
active after restart.
<TAflowcontrol>
(num)(&W)
To Next Page
Loading...
Need help?
General
