TC35i AT Command Set
12.3 AT^SSET
s
m
obil
e
TC35i_ATC_V02.07 Page 331 of 439 1/30/04
Confidential / Released
12.3 AT^SSET Indicate SIM data ready
After power on and personalization (PIN entry if required) the ME starts reading data from SIM. With this com-
mand it is possible to enable URC "
^SSIM READY" indication on the corresponding serial channel when this pro-
cess has been completed. Afterwards all commands that depends on SIM data fields can be used, e.g. the SMS
and phone book commands.
AT^SSET setting is storable via AT&W.
Syntax
Unsolicited Result Code
^SSIM READY
The URC acknowledges to the user that SIM data is accessible. Before that, any attempt to access one of the
phonebooks, view SMS or access SIM data will result in "+CME ERROR: 14" (SIM busy).
Test Command
AT^SSET=?
Response(s)
^SSET:(list of supported <n>s)
OK
Read Command
AT^SSET?
Response(s)
^SSET: <n>
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SSET=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
SIEMENS
To Next Page
Loading...
Need help?
General
