TC35i AT Command Set
2.8 ATZ
s
m
obil
e
TC35i_ATC_V02.07 Page 38 of 439 1/30/04
Confidential / Released
2.8 ATZ Set all current parameters to user defined profile
Syntax
Command Description
TA sets all current parameters to the user profile stored with AT&W. If a connection is in progress, it will be termi-
nated.
The user defined profile is stored to the non-volatile memory.
Parameter Description
[0] Reset to user profile
Notes
• First the profilewill be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W), this
profile will be loaded afterwards.
• Any additional commands on the same command line may be ignored. A delay of 300 ms is required before
next command is sent, otherwise "OK" response may be corrupted.
Exec Command
ATZ[<value>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
V.25ter
<value>
(num)
To Next Page
Loading...
Need help?
General
