Siemens TC35i Terminal User Manual

TC35i AT Command Set
11.7 AT+CMGS
s
m obil e
TC35i_ATC_V02.07 Page 286 of 439 1/30/04
Confidential / Released
11.7 AT+CMGS Send SMS message
Syntax
Command Description
The write command transmits a short message from TE to network (SMS-SUBMIT).
After invoking the write command wait for the prompt ">" and then start to write the message. To send the mes-
sage simply enter
<CTRL-Z>. After the prompt a timer will be started to observe the input.
To abort sending use
<ESC>. Abortion is acknowledged with "OK", though the message will not be sent.
The message reference
<mr> is returned to the TE on successful message delivery. The value can be used to
identify the message in a delivery status report provided as an unsolicited result code.
Notes
• If sending fails, for example, if a message is too long, the result code depends on the current setting of the
AT^SM20 command:
Test Command
AT+CMGS=?
Response(s)
OK
Write Command
If text mode (see AT+CMGF=1)
AT+CMGS=<da>[, <toda>]<CR> Text can be entered. <CTRL-Z>/<ESC>
Response(s)
+CMGS: <mr>[, <scts>]
OK
If sending fails see notes below.
Write Command
If PDU mode (see AT+CMGF=0)
AT+CMGS=<length><CR> PDU can be entered. <CTRL-Z>/<ESC>
Response(s)
+CMGS: <mr>[, <ackpdu>]
OK
If sending fails see notes below.
PIN ASC0 MUX1 MUX2 MUX3
% % % % %
Reference(s)
GSM 07.05

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English